Stp Commands - D-Link DWS-1008 Cli Reference Manual

Use Spanning Tree Protocol (STP) commands to configure and manage spanning trees on the virtual
LANs (VLANs) configured on a switch, to maintain a loop-free network. This chapter presents STP
commands alphabetically. Use the following table to locate commands in this chapter based on their
use.
STP State
Bridge Priority
Port Cost
Port Priority
Timers
Fast Convergence
Statistics
D-Link DWS-1008 CLI Manual

STP Commands

set spantree on page 492
show spantree on page 502
show spantree blockedports on page 506
set spantree priority on page 501
set spantree portcost on page 496
set spantree portvlancost on page 499
show spantree portvlancost on page 508
clear spantree portcost on page 488
clear spantree portvlancost on page 490
set spantree portpri on page 498
set spantree portvlanpri on page 500
clear spantree portpri on page 489
clear spantree portvlanpri on page 491
set spantree fwddelay on page 494
set spantree hello on page 495
set spantree maxage on page 495
set spantree portfast on page 498
show spantree portfast on page 507
set spantree backbonefast on page 493
show spantree backbonefast on page 506
set spantree uplinkfast on page 502
show spantree uplinkfast on page 516
show spantree statistics on page 509
clear spantree statistics on page 492
8