Set Enablepass - D-Link DWS-1008 Cli Reference Manual

quit
Exit from the CLI session.
Syntax: quit
Defaults: None.
Access: All.
Examples: To end the administrator's session, type the following command:
DWS-1008> quit

set enablepass

Sets the password that provides enabled access (for configuration and monitoring) to the
switch.
Syntax: set enablepass
Defaults: None.
Access: Enabled.
Usage: After typing the set enablepass command, press Enter. If you are entering the first
enable password on this switch, press Enter at the Enter old password prompt. Otherwise, type
the old password. Then type a password of up to 32 alphanumeric characters with no spaces,
and reenter it at the retype new password prompt.
Examples: The following example illustrates the prompts that the system displays when the
enable password is changed. The passwords you enter are not displayed.
DWS-1008# set enablepass
Enter old password: old-password
Enter new password: new-password
Retype new password: new-password
Password changed
D-Link DWS-1008 CLI Manual 1