Set Snmp Protocol - D-Link DWS-1008 Cli Reference Manual
8 port 10/100 wireless switch with power over ethernet
Hide thumbs
Also See for DWS-1008:
- Product manual (502 pages) ,
- User manual (454 pages) ,
- Cli reference manual (406 pages)
Table of Contents
Advertisement
This command configures target 1 at IP address 10.10.40.9. The target's SNMP engine ID is
based on its address. The MSS SNMP engine will send notifications based on the default profile,
and will require the target to acknowledge receiving them.
The following command configures a notification target for unacknowledged notifications:
DWS-1008# set snmp notify target 2 10.10.40.10 v1 trap
success: change accepted.
See Also:
• clear snmp notify target
• set ip snmp server
• set snmp community
• set snmp notify profile
• set snmp protocol
• set snmp security
• set snmp usm
• show snmp notify target
set snmp protocol
Enables an SNMP protocol. MSS supports SNMPv1, SNMPv2c, and SNMPv3.
Syntax: set snmp protocol {v1 | v2c | usm | all} {enable | disable}
v1
v2c
usm
all
enable
disable
Defaults: All SNMP versions are disabled by default.
Access: Enabled.
Usage: SNMP requires the switch's system IP address to be set. SNMP will not work without
the system IP address. You also must enable the SNMP service using the set ip snmp server
command.
Examples: The following command enables all SNMP versions:
DWS-1008# set snmp protocol all enable
success: change accepted.
D-Link DWS-1008 CLI Manual
SNMPv1
SNMPv2c
SNMPv3 (with the user security model)
Enables all supported versions of SNMP.
Enables the specified SNMP version(s).
Disables the specified SNMP version(s).
111
Advertisement
Table of Contents
