D-Link DWS-1008 Cli Reference Manual page 304

set boot backup-configuration
Specifies the name of a backup configuration file to be used in the event that MSS cannot read
the switch's configuration file at boot time.
Syntax: set boot backup-configuration filename
filename
Defaults: By default, there is no backup configuration file.
Access: Enabled.
Examples: The following command specifies a file called backup.cfg as the backup configuration
file on the switch:
DWS-1008# set boot backup-configuration backup.cfg
success: backup boot config filename set.
See Also:
• clear boot backup-configuration
• show boot
set boot configuration-file
Changes the configuration file to load after rebooting.
Syntax: set boot configuration-file filename
filename
Defaults: The default configuration filename is configuration.
Access: Enabled.
Usage: The file must be located in the switch's nonvolatile storage.
Examples: The following command sets the boot configuration file to testconfig1:
DWS-1008# set boot configuration-file testconfig1
success: boot config set.
D-Link DWS-1008 CLI Manual
Name of the file to use as a backup configuration file if MSS cannot
read the switch's configuration file.
Filename. Specify between 1 and 128 alphanumeric characters, with
no spaces.
To load the file from a subdirectory, specify the subdirectory name,
followed by a forward slash, in front of the filename. For example:
backup_configs/config_c.
01