Set Spantree; Set Spantree Backbonefast - D-Link DWS-1008 Cli Reference Manual

set spantree

Enables or disables STP on one VLAN or all VLANs configured on a DWS-1008 switch.
Syntax: set spantree {enable | disable} [{all | vlan vlan-id | port port-list vlan-id}]
enable
disable
all
vlan vlan-id
port port-list vlan-id
Defaults: Disabled.
Access: Enabled.
Examples: The following command enables STP on all VLANs configured on a switch:
DWS-1008# set spantree enable
success: change accepted.
The following command disables STP on VLAN burgundy:
DWS-1008# set spantree disable vlan burgundy
success: change accepted.
See Also:
• show spantree

set spantree backbonefast

Enables or disables STP backbone fast convergence on a switch. This feature accelerates a
port's recovery following the failure of an indirect link.
Syntax: set spantree backbonefast {enable | disable}
enable
disable
D-Link DWS-1008 CLI Manual
Enables STP.
Disables STP.
Enables or disables STP on all VLANs.
VLAN name or number. MSS enables or disables STP on only the
specified VLAN, on all ports within the VLAN.
Port number or list and the VLAN the ports are in. MSS enables or
disables STP on only the specified ports, within the specified VLAN.
Enables backbone fast convergence.
Disables backbone fast convergence.