D-Link DWS-1008 Cli Reference Manual page 527

reset
Resets a DWS-1008 switch's hardware.
Syntax: reset
Defaults: None.
Access: Boot prompt.
Usage: After resetting the hardware, the reset command attempts to load a system image file
only if other boot settings are configured to do so.
Examples: To immediately reset the system, type the following command at the boot prompt:
boot> reset
D-Link Systems Bootstrap 1.17 Release
Testing Low Memory 1 ............
Testing Low Memory 2 ............
CISTPL_VERS_1: 4.1 <SanDisk> <SDP> <5/3 0.6>
Reset Cause (0x02) is COLD
D-Link Systems Bootstrap/Bootloader
Version 1.6.5 Release
Bootstrap 0 version:
Bootloader 0 version:
Bootstrap 1 version:
Bootloader 1 version:
Board Revision:
Controller Revision:
POE Board Revision:
POE Controller Revision:
BOOT Index:
BOOT TYPE:
DEVICE:
FILENAME:
FLAGS:
OPTIONS:
See Also:
• boot
D-Link DWS-1008 CLI Manual
1.17 Active
1.6.5 Active
1.17
1.6.3
3.
24.
1
6
0
c
boot1:
default
00000000
run=nos;boot=0