Radius And Server Groups Commands - D-Link DWS-1008 Cli Reference Manual

8 port 10/100 wireless switch with power over ethernet

Hide thumbs Also See for DWS-1008:

Table of Contents

RADIUS and Server Groups Commands

Use RADIUS commands to set up communication between a switch and groups of up to four RADIUS

servers for remote authentication, authorization, and accounting (AAA) of administrators and network

users. This chapter presents RADIUS commands alphabetically. Use the following table to locate

commands in this chapter based on their uses.

RADIUS Client

RADIUS Servers

Server Groups

RADIUS Proxy

(For information about RADIUS attributes, see the RADIUS appendix in the D-Link Mobility System

Software Configuration Guide.)

D-Link DWS-1008 CLI Manual

set radius client system-ip on page 234

clear radius client system-ip on page 229

set radius on page 232

set radius server on page 236

clear radius on page 228

clear radius server on page 231

set server group on page 238

set server group load-balance on page 239

clear server group on page 231

set radius proxy client on page 234

set radius proxy port on page 235

clear radius proxy client on page 230

clear radius proxy port on page 230