Set Vlan Port - D-Link DWS-1008 Cli Reference Manual

VLAN names are case-sensitive for RADIUS authorization when a client roams to a switch. If the
switch is not configured with the VLAN the client is on, but is configured with a VLAN that has
the same spelling but different capitalization, authorization for the client fails. For example, if the
client is on VLAN red but the switch to which the client roams has VLAN RED instead, RADIUS
authorization fails.
Examples: The following command assigns the name marigold to VLAN 3:
DWS-1008# set vlan 3 name marigold
success: change accepted.
See Also:

• set vlan port

set vlan port
Assigns one or more network ports to a VLAN. You also can add a virtual port to each network
port by adding a tag value to the network port.
Syntax: set vlan vlan-id port port-list [tag tag-value]
vlan-id
port port-list
tag tag-value Tag value that identifies a virtual port. You can specify a value from 1 through
Defaults: By default, no ports are members of any VLANs. A switch cannot forward traffic on the
network until you configure VLANs and add network ports to the VLANs.
Access: Enabled.
Usage: You can combine this command with the set port name command to assign the name
and add the ports at the same time. If you do not specify a tag value, the switch sends untagged
frames for the VLAN. If you do specify a tag value, the switch sends tagged frames only for the
VLAN.
If you do specify a tag value, D-Link recommends that you use the same value as the VLAN
number. MSS does not require the VLAN number and tag value to be the same but some other
vendors' devices do.
Examples: The following command assigns the name beige to VLAN 11 and adds ports 1 through
3 to the VLAN:
DWS-1008# set vlan 11 name beige port 1-3
success: change accepted.
The following command adds port 5 to VLAN beige and assigns tag value 86 to the port:
DWS-1008# set vlan beige port 5 tag 86
success: change accepted.
D-Link DWS-1008 CLI Manual
VLAN name or number.
List of physical ports.
4093.