D-Link DWS-1008 Cli Reference Manual page 355

Examples: The following command changes the RTS threshold for radio profile rp1 to 1500
bytes:
DWS-1008# set radio-profile rp1 rts-threshold 1500
success: change accepted.
See Also:
• set radio-profile mode
• show radio-profile
set radio-profile service-profile
Maps a service profile to a radio profile. All radios that use the radio profile also use the parameter
settings, including SSID and encryption settings, in the service profile.
Syntax: set radio-profile name service-profile name
radio-profile name
service-profile name
Defaults: A radio profile does not have a service profile associated with it by default. In this case,
the radios in the radio profile use the default settings for parameters controlled by the service
profile. The following table lists the parameters controlled by a service profile and their default
values.
Parameter
attr
auth-dot1x
auth-fallthru
auth-psk
beacon
D-Link DWS-1008 CLI Manual
Radio profile name of up to 16 alphanumeric characters, with no
spaces.
Service profile name of up to 16 alphanumeric characters, with no
spaces.
Default Value
No attributes configured
enable
none
none
enable
Radio Behavior When Parameter Set to Default Value
Does not assign the SSID's authorization attribute
values to SSID users, even if attributes are not
otherwise assigned.
When the Wi-Fi Protected Access (WPA) information
element (IE) is enabled, uses 802.1X to authenticate
WPA clients.
Denies access to users who do not match an 802.1X
or MAC authentication fule for the SSID requested by
the user.
Does not support using a preshared key (PSK) to authenticate
WPA clients.
Sends beacons to advertise the SSID managed by the service
profile.