Set Port Type Ap - D-Link DWS-1008 Cli Reference Manual

set port type ap

Configures a DWS-1008 switch port for an (AP) access point.
Caution! When you set the port type for AP use, you must specify the PoE state (enable or
disable) of the port. Use the DWS-1008's PoE to power D-Link access points or PoE enabled
devices only. If you enable PoE on a port connected to another device, physical damage to the
device can result.
Note: Before configuring a port as an AP port, you must use the set system countrycode
command to set the IEEE 802.11 country-specific regulations on the DWS-1008. See set
system countrycode.
Note: For an AP that is indirectly connected to the DWS-1008 through an intermediate Layer
2 or Layer 3 network, use the set dap command to configure a Distributed AP.
Note: Before changing the port type from ap to wired-auth or from wired-auth to ap, you must
reset the port with the clear port type command.
Syntax: set port type ap port-list model {DWL-8200} poe {enable | disable}
[radiotype {11a | 11b| 11g}]
port-list
model
poe enable | disable
radiotype 11a | 11b | 11g
Defaults: All DWS-1008 ports are network ports by default.
Access: Enabled.
Usage: You cannot set a port's type if the port is a member of a port VLAN. To remove a port
from a VLAN, use the clear vlan command. To reset a port as a network port, use the clear
port type command.
When you change port type, MSS applies default settings appropriate for the port type. The
following Table lists the default settings that MSS applies when you set a port's type to ap.
D-Link DWS-1008 CLI Manual
List of physical ports.
Access: point model.
Power over ethernet (PoE) state.
Radio type:
• 11a - 802.11a
• 11b - 802.11b
• 11g - 802.11g
Note: This option applies only to single radio models.
1