Set Ip Telnet Server - D-Link DWS-1008 Cli Reference Manual

8 port 10/100 wireless switch with power over ethernet

Hide thumbs Also See for DWS-1008:

Table of Contents

Defaults: The default Telnet port number is 23.

Access: Enabled.

Examples: The following command changes the Telnet port number on a switch to 5000:

DWS-1008# set ip telnet 5000

success: change accepted.

• set ip telnet server

• show ip https

• show ip telnet

set ip telnet server

Enables the Telnet server on a DWS-1008 switch.

Caution: If you disable the Telnet server, Telnet access to the switch is also disabled.

Syntax: set ip telnet server {enable | disable}

Enables the Telnet server.

Disables the Telnet server.

Defaults: The Telnet server is disabled by default.

Access: Enabled.

Usage: The maximum number of Telnet sessions supported on a DWS-1008 switch is eight. If

SSH is also enabled, the switch can have up to eight Telnet or SSH sessions, in any combination,

and one console session.

Examples: The following command enables the Telnet server on a DWS-1008 switch:

DWS-1008# set ip telnet server enable

success: change accepted.