Show Ip Https - D-Link DWS-1008 Cli Reference Manual

show ip https

Displays information about the HTTPS management port.
Syntax: show ip https
Defaults: None.
Access: All.
Examples: The following command shows the status and port number for the HTTPS management
interface to the switch:
DWS-1008> show ip https
HTTPS is enabled
HTTPS is set to use port 443
Last 10 Connections:
IP Address
-----------------------------------------------------------------------------
10.10.10.56 2003/05/09
The table below describes the fields in this display.
Field
HTTPS is
enabled/disabled
HTTPS is set to use port
Last 10 connections
IP Address
Last Connected
Time Ago (s)
See Also:
• clear ip telnet
• set ip https server
• set ip telnet
• set ip telnet server
• show ip telnet
D-Link DWS-1008 CLI Manual
Last Connected Time Ago (s)
15:51:26 pst 349
State of the HTTPS server:
• Enabled
• Disabled
TCP port number on which the switch listens for HTTPS connections.
List of the last 10 devices to establish connections to the switch's
HTTPS server.
IP address of the device that established the connection.
Note: If a browser connects to a switch from behind a proxy, then only
the proxy IP address is shown. If multiple browsers connect using the
same proxy, the proxy address appears only once in the output.
Time when the device established the HTTPS connection to the
switch.
Number of seconds since the device established the HTTPS connection
to the switch.
Description
1