D-Link DWS-1008 Cli Reference Manual page 464

IGMP message type
----------------------------------------------------------------------------------------
General-Queries
GS-Queries
Report V1
Report V2
Leave
Mrouter-Adv
Mrouter-Term
Mrouter-Sol
DVMRP
PIM V1
PIM V2
Topology notifications: 0
Packets with unknown IGMP type: 0
Packets with bad length: 0
Packets with bad checksum: 0
Packets dropped: 4
The table below describes the fields in this display.
Field
VLAN
IGMP is enabled (disabled)
Proxy reporting
Mrouter solicitation
Querier functionality
Configuration values (qi)
Configuration values (oqi)
Configuration values (qri)
Configuration values (lmqi)
Configuration values (rvalue)
Multicast router information
Port
Mrouter-IPaddr
Mrouter-MAC
Type
D-Link DWS-1008 CLI Manual
Received Transmitted Dropped
0 0
0 0
0 0
5 1
0 0
0 0
0 0
50 101
4 4
0 0
0 0
VLAN name. MSS displays information separately for each VLAN.
IGMP state.
Proxy reporting state.
Multicast router solicitation state.
Pseudo-querier state.
Query interval.
Other-querier-present interval.
Query response interval.
Last member query interval.
Robustness value.
List of multicast routers and active multicast groups. The fields containing this
information are described separately. The show igmp mrouter command shows the
same information.
Number of the physical port through which the switch can reach the router.
IP address of the multicast router interface.
MAC address of the multicast router interface.
How the switch learned that the port is a multicast router port:
• conf — Static multicast port configured by an administrator
• madv—Multicast advertisement
• quer—IGMP query
• dvmrp—Distance Vector Multicast Routing Protocol (DVMRP)
• pimv1—Protocol Independent Multicast (PIM) version 1
• pimv2—PIM version 2
0
0
0
4
0
0
0
0
0
0
0
Description
1