D-Link DWS-1008 Cli Reference Manual page 337

set radio-profile active-scan
Disables or reenables active RF detection scanning on the DWL-8220AP radios managed by a
radio profile. When active scanning is enabled, DWL-8220AP radios look for rogue devices by
sending probe any requests (probe requests with a null SSID name), to solicit probe responses
from other access points.
Passive scanning is always enabled and cannot be disabled. During passive scanning, radios
look for rogues by listening for beacons and probe responses.
Syntax: set radio-profile name active-scan {enable | disable}
Radio profile name.
name
enable Configures radios to actively scan for rogues.
Configures radios to scan only passively for rogues by listening for beacons and
disable
probe responses.
Defaults: Active scanning is enabled by default.
Access: Enabled.
Usage: You can enter this command on any DWS-1008 switch. The command takes effect only
on that switch.
Examples: The following command disables active scan in radio profile radprof3:
DWS-1008# set radio-profile radprof3 active-scan disable
success: change accepted.
See Also:
• show radio-profile
set radio-profile auto-tune channel-config
Disables or reenables dynamic channel tuning (RF Auto-Tuning) for the DWL-8220AP radios in
a radio profile.
Syntax: set radio-profile name auto-tune channel-config {enable | disable}
D-Link DWS-1008 CLI Manual