Show Spantree Blockedports - D-Link DWS-1008 Cli Reference Manual

show spantree backbonefast
Indicates whether the STP backbone fast convergence feature is enabled or disabled.
Syntax: show spantree backbonefast
Defaults: None.
Access: All.
Examples: The following example shows the command output on a switch with backbone fast
convergence enabled:
DWS-1008# show spantree backbonefast
Backbonefast is enabled
See Also:
• set spantree backbonefast

show spantree blockedports

Lists information about switch ports that STP has blocked on one or all of its VLANs.
Syntax: show spantree blockedports [vlan vlan-id]
vlan vlan-id
Defaults: None.
Access: All.
Usage: The command lists information separately for each VLAN.
Examples: The following command shows information about blocked ports on a switch for the
default VLAN (VLAN 1):
DWS-1008# show spantree blockedports vlan default
Port Vlan
------------------------------------------------------------------------
6 190
Number of blocked ports (segments) in VLAN 1 : 1
The port information is the same as the information displayed by the show spantree command.
See Also:
• show spantree
D-Link DWS-1008 CLI Manual
VLAN name or number. If you do not specify a VLAN, MSS displays information
for blocked ports on all VLANs.
Port-State Cost Prio
Blocking 4
Portfast
128 Disabled