Boot Prompt Commands - D-Link DWS-1008 Cli Reference Manual

Boot Prompt Commands

Boot prompt commands enable you to perform basic tasks, including booting a system image file, from
the boot prompt (boot>). A CLI session enters the boot prompt if MSS does not boot successfully or
you intentionally interrupt the boot process. To interrupt the boot process, press q followed by Enter
(return).
Caution: Generally, boot prompt commands are used only for troubleshooting. D-Link recommends
that you use these commands only when working with D-Link to diagnose a system issue. In particular,
commands that change boot parameters can interfere with a switch's ability to boot successfully.
This chapter presents boot prompt commands alphabetically. Use the following table to locate commands
in this chapter based on their use.
Command Information
Booting
File Management
Boot Profile Management
Diagnostics
D-Link DWS-1008 CLI Manual
help on page 521
ls on page 522
autoboot on page 514
boot on page 514
dhcp on page 518
reset on page 524
dir on page 519
fver on page 520
version on page 527
change on page 516
create on page 517
delete on page 518
next on page 523
show on page 525
diag on page 519
test on page 527
1