D-Link DWS-1008 Cli Reference Manual page 42

Usage: Each type of statistic is displayed separately. Press the Spacebar to cycle through the
displays for each type.
If you use an option to specify a statistic type, the display begins with that statistic type. You can
use one statistic option with the command.
Use the keys listed the following table to control the monitor display
Key
Spacebar
Esc
c
For error reporting, the cyclic redundancy check (CRC) errors include misalignment errors.
Jumbo packets with valid CRCs are not counted. A short packet can be reported as a short
packet, a CRC error, or an overrun. In some circumstances, the transmitted octets counter
might increment a small amount for a port with nothing attached.
Examples: The following command starts the port statistics monitor beginning with octet
statistics (the default):
Syntax: monitor port counters
As soon as you press Enter, MSS clears the window and displays statistics at the top of the
window.
Port Status
=========================================
1 Up
...
To cycle the display to the next set of statistics, press the Spacebar. In this example, packet
statistics are displayed next:
Port Status
===========================================================
1 Up
...
The following table describes the port statistics displayed by each statistics option. The Port and
Status fields are displayed for each option.
D-Link DWS-1008 CLI Manual
Effect on monitor display
Advances to the next statistic type.
Exits the monitor. MSS stops displaying the statistics and displays a new command
prompt.
Clears the statistics counters for the currently displayed statistics type. The counters
begin incrementing again.
Rx Octets
27965420
Rx Unicast Rx NonUnicast
54620 62144
Tx Octets
34886544
Tx Unicast
58318
Tx NonUnicast
62556