D-Link DWS-1008 Cli Reference Manual page 420
8 port 10/100 wireless switch with power over ethernet
Hide thumbs
Also See for DWS-1008:
- Product manual (502 pages) ,
- User manual (454 pages) ,
- Cli reference manual (406 pages)
Table of Contents
Advertisement
show dap connection
Displays the system IP address of the DWS-1008 that booted a Distributed AP.
Syntax: show dap connection [dap-num | serial-id serial-ID]
dap-num
serial-id
Defaults: None.
Access: Enabled.
Usage: The serial-id parameter displays the active connection for the specified Distributed AP
even if that AP is not configured on this DWS-1008. If you instead use the command with the
dap-num parameter or without a parameter, connection information is displayed only for Distributed
APs that are configured on this DWS-1008.
This command provides information only if the Distributed AP is configured on the switch where
you use the command. The switch does not need to be the one that booted the AP, but it must
have the AP in its configuration.
If a Distributed AP is configured on this DWS-1008 but does not have an active connection,
the command does not display information for the AP. To show connection information for
Distributed APs, use the show dap global command on one of the switches where the APs are
configured.
Examples: The following command displays information for all Distributed APs configured on
this DWS-1008 that have active connections:
DWS-1008# show dap connection
Total number of entries: 2
DAP Serial Id
2
4
D-Link DWS-1008 CLI Manual
Number of a Distributed AP for which to display information about its active
connection.
DWL-8220AP access point serial ID.
DAP IP Address DWS-1008 IP Address
112233
10.10.2.27
0333000298 10.10.3.34
10.3.8.111
10.3.8.111
1
Advertisement
Table of Contents
