D-Link DWS-1008 Cli Reference Manual page 443

Defaults: None.
Access: All.
Examples: The following command displays STP information for VLAN default:
DWS-1008# show spantree vlan default
VLAN 1
Spanning Tree Mode
Spanning Tree Type
Spanning Tree Enabled
Designated Root
Designated Root
Designated Root Path Cost
Designated Root Port
Root Max Age 20 sec
Bridge ID MAC ADDR
Bridge ID Priority
Bridge Max Age 20 sec
Port Vlan STP-State
-------------------------------------------------------------------
1 1 Forwarding 19
2 1 STP Off
3 1 Disabled
4 1 Disabled
5 1 Disabled
6 1 Disabled
The table below describes the fields in this display.
Field
VLAN
Spanning Tree Mode
Spanning Tree Type
Spanning Tree Enabled
Designated Root
Designated Root Priority
Designated Root Path Cost
Designated Root Port
Root Max Age
Root Hello Time
Root Forward Delay
Bridge ID MAC ADDR
D-Link DWS-1008 CLI Manual
PVST+
IEEE
00-02-4a-70-49-f7
Priority 32768
19
1
Hello Time 2 sec
00-0b-0e-02-76-f7
32768
Hello Time 2 sec
Cost Prio Portfast
128 Disabled
19 128 Disabled
19 128 Disabled
19 128 Disabled
19 128 Disabled
19 128 Disabled
VLAN number.
In the current software version, the mode is always PVST+, which means Per VLAN
Spanning Tree+.
In the current software version, the type is always IEEE, which means STP is based on
the IEEE 802 standards.
State of STP on the VLAN.
MAC address of the spanning tree's root bridge.
Bridge priority of the root bridge.
Cumulative cost from this bridge to the root bridge. If this switch is the root bridge, then
the root cost is 0.
Port through which this switch reaches the root bridge. If this switch is the root bridge,
this field says We are the root.
Maximum acceptable age for hello packets on the root bridge.
Hello interval on the root bridge.
Forwarding delay value on the root bridge.
This switch's MAC address.
Forward Delay 15 sec
Forward Delay 15 sec
Description
0