Show Rfdetect Counters - D-Link DWS-1008 Cli Reference Manual

Usage: This command is valid only on the seed switch
Examples: The following example displays countermeasures status:
DWS-1008# show rfdetect countermeasures
Total number of entries: 190
Rogue MAC
-----------------
00:0b:0e:00:71:c0 intfr
00:0b:0e:03:00:80 rogue 00:0b:0e:11:22:33
The table below describes the fields in this display.
Field
Rogue MAC
Type
Countermeasures Radio
MAC
IPaddr
Port/Radio/Channel
See Also:
• set radio-profile countermeasures

show rfdetect counters

Displays statistics for rogue and Intrusion Detection System (IDS) activity detected by the APs
managed by a switch.
Syntax: show rfdetect counters
Defaults: None.
Access: Enabled.
D-Link DWS-1008 CLI Manual
Type Countermeasures
Radio Mac
----- ------------------
00:0b:0e:44:55:66
BSSID of the rogue.
Classification of the rogue device:
• rogue—Wireless device that is on the network but is not supposed to be on the
network.
• intfr—Wireless device that is not part of your network and is not a rogue, but
might be causing RF interference with AP radios.
• known—Device that is a legitimate member of the network.
MAC address of the D-Link radio sending countermeasures against the rogue.
System IP address of the switch that is managing the AP that is sending or will
send countermeasures.
Port number, radio number, and channel number of the countermeasures radio.
For a Distributed AP, the connection number is labeled dap. (This stands for
distributed ap.)
IPaddr
---------------
10.1.1.23
10.1.1.23
Description
Port/Radio
/Channel
-------------
dap 4/1/6
dap 2/1/11
8