Access Commands - D-Link DWS-1008 Cli Reference Manual

8 port 10/100 wireless switch with power over ethernet

Hide thumbs Also See for DWS-1008:

Table of Contents

Use access commands to control access to the Mobility Software System (MSS) (CLI). This chapter

presents access commands alphabetically. Use the following table to locate commands in this chapter

based on their use.

Defaults: None.

Access: Enabled.

Places the CLI session in enabled mode, which provides access to all commands required for

configuring and monitoring the system.

Syntax: enable

Access: All.

Usage: MSS displays a password prompt to challenge you with the enable password. To enable

a session, your or another administrator must have configured the enable password to this

switch with the set enablepass command.

Examples: The following command plus the enable password provides enabled access to the

CLI for the current sessions:

DWS-1008> enable

Enter password: password

D-Link DWS-1008 CLI Manual

Access Commands