D-Link DWS-1008 Cli Reference Manual page 276

Usage: The command applies only to APs managed by the switch on which you enter the
command. To enable signatures on all APs, enter the command on each switch.
Note: You must use the same AP signature setting (enabled or disabled) on all switches.
Examples: The following command enables AP signatures on an switch:
DWS-1008# set rfdetect signature enable
success: signature is now enabled.
set rfdetect ssid-list
Adds an SSID to the permitted SSID list. The permitted SSID list specifies the SSIDs that are
allowed on the network. If MSS detects packets for an SSID that is not on the list, the AP that
sent the packets is classified as a rogue. MSS issues countermeasures against the rogue if they
are enabled.
Syntax: set rfdetect ssid-list ssid-name
ssid-name
Defaults: The permitted SSID list is empty by default and all SSIDs are allowed. However, after
you add an entry to the list, MSS allows traffic only for the SSIDs that are on the list.
Access: Enabled.
Usage: The permitted SSID list applies only to the switch on which the list is configured. Switches
do not share permitted SSID lists.
If you add a device that MSS has classified as a rogue to the permitted SSID list, but not to the
ignore list, MSS can still classify the device as a rogue. Adding an entry to the permitted SSID
list merely indicates that the device is using an allowed SSID. However, to cause MSS to stop
classifying the device as a rogue, you must add the device's MAC address to the ignore list.
Examples: The following command adds SSID mycorp to the list of permitted SSIDs:
DWS-1008# set rfdetect ssid-list mycorp
success: ssid mycorp is now in ssid-list.
See Also:
• clear rfdetect ssid-list
• show rfdetect ssid-list
D-Link DWS-1008 CLI Manual
SSID name you want to add to the permitted SSID list.