Set Boot Partition; Show Boot - D-Link DWS-1008 Cli Reference Manual

set boot partition

Specifies the boot partition in which to look for the system image file following the next system
reset, software reload, or power cycle.
Syntax: set boot partition {boot0 | boot1}
boot0
boot1
Defaults: By default, a switch uses the same boot partition for the next software reload that was
used to boot the currently running image.
Access: Enabled.
Usage: To determine the boot partition that was used to load the currently running software
image, use the dir command.
Examples: The following command sets the boot partition for the next software reload to partition 1:
DWS-1008# set boot partition boot1
success: Boot partition set to boot1.

show boot

Displays the system image and configuration filenames used after the last reboot and configured
for use after the next reboot.
Syntax: show boot
Defaults: None.
Access: Enabled.
Examples: The following command shows the boot information for a switch:
DWS-1008# show boot
Configured boot version:
Configured boot image:
Configured boot configuration:
Backup boot configuration:
Booted version:
Booted image:
Booted configuration:
Product model:
D-Link DWS-1008 CLI Manual
Boot partition 0.
Boot partition 1.
4.1.0.65
boot1:mx040100.020
file:configuration
file:backup.cfg
4.1.0.65
boot1:mx040100.020
file:configuration
switch
0