Show Rfdetect Countermeasures - D-Link DWS-1008 Cli Reference Manual

Type
Last seen
show rfdetect clients mac Output
Field
RSSI
Rate
Last Seen
BSSID
Vendor
Typ
Dst
Last Rogue Status
Check

show rfdetect countermeasures

Displays the current status of countermeasures against rogues.
Syntax: show rfdetect countermeasures
Defaults: None.
Access: Enabled.
D-Link DWS-1008 CLI Manual
Classification of the rogue device:
• rogue—Wireless device that is on the network but is not supposed to be
on the network.
• intfr—Wireless device that is not part of your network and is not a rogue,
but might be causing RF interference with AP radios.
• known—Device that is a legitimate member of the network.
Number of seconds since an AP radio last detected 802.11 packets from
the device.
Description
Received signal strength indication (RSSI)—the strength of the RF signal
detected by the AP radio, in decibels referred to 1 milliwatt (dBm).
The data rate of the client.
Number of seconds since an AP radio last detected 802.11 packets from
the device.
MAC address of the SSID with which the rogue client is associated.
Company that manufactures or sells the AP with which the rogue client is
associated.
Classification of the rogue device:
• rogue—Wireless device that is on the network but is not supposed to be
on the network.
• intfr—Wireless device that is not part of your network and is not a rogue,
but might be causing RF interference with AP radios.
• known—Device that is a legitimate member of the network.
MAC addressed to which the last 802.11 packet detected from the client
was addressed.
Number of seconds since the switch looked on the air for the AP with
which the rogue client is associated. The switch looks for the client's AP
by sending a packet from the wired side of the network addressed to the
client, and watching the air for a wireless packet containing the client's
MAC address.