D-Link DWS-1008 Cli Reference Manual page 487

show security acl hits
Displays the number of packets filtered by security ACLs ("hits") on the switch. Each time a
packet is filtered by a security ACL, the hit counter increments.
Syntax: show security acl hits
Defaults: None.
Access: Enabled.
Usage: For MSS to count hits for a security ACL, you must specify hits in the set security acl
commands that define ACE rules for the ACL.
Examples: To display the security ACL hits on a switch, type the following command:
DWS-1008# show security acl hits
ACL hit-counters
Index Counter
-------------------------------------------
1 0
2 0
3 916
See Also:
• hit-sample-rate
• set security acl
show security acl info
Displays the contents of a specified security ACL or all security ACLs that are committed—saved
in the running configuration and nonvolatile storage—or the contents of security ACLs in the edit
buffer before they are committed.
Syntax: show security acl info [acl-name | all] [editbuffer]
acl-name
all
editbuffer
D-Link DWS-1008 CLI Manual
ACL-name
acl_2
acl_175
acl_123
Name of an existing security ACL to display. ACL names must start with a
letter and are case-insensitive.
Displays the contents of all security ACLs.
Displays the contents of the specified security ACL or all security ACLs that
are stored in the edit buffer after being created with set security acl. If you do
not use this parameter, only committed ACLs are shown.
8