Rf Detection Commands - D-Link DWS-1008 Cli Reference Manual

RF Detection Commands

MSS automatically performs RF detection scans on enabled and disabled radios to detect rogue access
points. A rogue access point is a BSSID (MAC address associated with an SSID) that does not belong
to a D-Link device and is not a member of the ignore list configured on the seed switch.
MSS can issue countermeasures against rogue devices to prevent clients from being able to use
them.
You can configure RF detection parameters on individual switches.
This chapter presents RF detection commands alphabetically. Use the following table to locate the
commands in this chapter based on their use.
Rogue Information
Countermeasures
Permitted Vendor List
Permitted SSID List
Client Black List
Attack List
Ignore List
AP Signatures
Log Messages
DWS-to-Client RF Link
D-Link DWS-1008 CLI Manual
show rfdetect clients on page 275
show rfdetect data on page 280
show rfdetect visible on page 283
show rfdetect counters on page 278
show rfdetect countermeasures on page 277
set rfdetect vendor-list on page 274
show rfdetect vendor-list on page 282
clear rfdetect vendor-list on page 269
set rfdetect ssid-list on page 273
show rfdetect ssid-list on page 282
clear rfdetect ssid-list on page 269
set rfdetect black-list on page 270
show rfdetect black-list on page 285
set rfdetect attack-list on page 270
show rfdetect attack-list on page 274
clear rfdetect attack-list on page 268
set rfdetect ignore on page 271
show rfdetect ignore on page 281
clear rfdetect ignore on page 268
set rfdetect signature on page 272
set rfdetect log on page 272
test rflink on page 284