Set Interface - D-Link DWS-1008 Cli Reference Manual

Access: Enabled.
Usage: Aging applies only to dynamic entries.
To reset the ARP aging timeout to its default value, use the set arp agingtime 1200 command.
Examples: The following command changes the ARP aging timeout to 1800 seconds:
DWS-1008# set arp agingtime 1800
success: set arp aging time to 1800 seconds
The following command disables ARP aging:
DWS-1008# set arp agingtime 0
success: set arp aging time to 0 seconds
See Also:
• set arp
• show arp

Set interface

Configures an IP interface on a VLAN.
Syntax: set interface vlan-id ip {ip-addr mask | ip-addr/mask-length}
vlan-id
ip-addr mask
ip-addr/mask-length IP address and subnet mask length in CIDR format (for example,
Defaults: None.
Access: Enabled.
Usage: You can assign one IP interface to each VLAN.
If an interface is already configured on the VLAN you specify, this command replaces the interface.
If you replace an interface that is in use as the system IP address, replacing the interface can
interfere with system tasks that use the system IP address, including the following:
• Topology reporting for dual-homed access points
• Default source IP address used in unsolicited communications such as AAA
accounting reports and SNMP traps
D-Link DWS-1008 CLI Manual
VLAN name or number.
IP address and subnet mask in dotted decimal notation (for example,
10.10.10.10 255.255.255.0).
10.10.10.10/24).
88