D-Link DWS-1008 Cli Reference Manual page 135

set ip telnet
Changes the TCP port number on which a DWS-1008 switch listens for Telnet management
traffic.
Caution: If you change the Telnet port number from a Telnet session, MSS immediately ends the
session. To open a new management session, you must Telnet to the switch with the new Telnet
port number.
Syntax: set ip telnet port-num
port-num TCP port number.
Defaults: The default Telnet port number is 23.
Access: Enabled.
Examples: The following command changes the Telnet port number on a DWS-1008 switch to
5000:
DWS-1008# set ip telnet 5000
success: change accepted.
See Also:
• clear ip telnet
• set ip https server
• set ip telnet server
• show ip https
• show ip telnet
set ip telnet server
Enables the Telnet server on a DWS-1008 switch.
Caution: If you disable the Telnet server, Telnet access to the switch is also disabled.
Syntax set ip telnet server {enable | disable}
enable Enables the Telnet server.
disable
Disables the Telnet server.
Defaults: The Telnet server is disabled by default.
Access: Enabled.
D-Link DWS-1008 CLI Manual 1