D-Link DWS-1008 Cli Reference Manual page 144

retries num
timeout num
SNMPv3 with Traps
To configure a notification target for traps from SNMPv3, use the following command:
Syntax: set snmp notify target target-num ip-addr [:udp-port-number]
usm trap user username [profile profile-name] [security {unsecured |
authenticated | encrypted}]
target-num
ip-addr[:udp-port-number] IP address of the server. You also can specify the UDP port number
username
profile profile-name
security {unsecured |
authenticated | encrypted}
D-Link DWS-1008 CLI Manual
Specifies the number of times the MSS SNMP engine will resend a
notification that has not been acknowledged by the target. You
can specify from 0 to 3 retries.
Specifies the number of seconds MSS waits for acknowledgement
of a notification. You can specify from 1 to 5 seconds.
ID for the target. This ID is local to the switch and does not need to
correspond to a value on the target itself. You can specify a number
from 1 to 10.
to send notifications to.
USM username. This option is applicable only when the SNMP
version is usm.
Notification profile this SNMP user will use to specify the notification
types to send or drop.
Specifies the security level, and is applicable only when the
SNMP version is usm:
• unsecured—Message exchanges are not authenticated,
nor are they encrypted. This is the default.
• authenticated—Message exchanges are authenticated,
but are not encrypted.
• encrypted—Message exchanges are authenticated and
encrypted.
11