Show Vlan Config - D-Link DWS-1008 Cli Reference Manual

Examples: The following command shows Layer 2 forwarding restriction information for all
VLANs:
DWS-1008# show security l2-restrict
VLAN Name
-------------------------------------------------------------------------------------------------
1 default
2 vlan-2
The table describes the fields in the display.
Field
VLAN
Name
En
Drops
Permit MAC
Hits
See Also:
• clear security l2-restrict
• clear security l2-restrict counters
• set security l2-restrict

show vlan config

Displays VLAN information.
Syntax: show vlan config [vlan-id]
vlan-id VLAN name or number. If you do not specify a VLAN, information for all VLANs is
displayed.
Defaults: None.
Access: All.
D-Link DWS-1008 CLI Manual
En Drops Permit MAC
Y 0 00:0b:0e:02:53:3e
00:30:b6:3e:5c:a8
Y 0 04:04:04:04:04:04
VLAN number.
VLAN name.
Enabled state of the feature for the VLAN:
• Y—Enabled. Forwarding of Layer 2 traffic from clients is restricted to the MAC address(es)
listed under Permit MAC.
• N—Disabled. Layer 2 forwarding is not restricted.
Number of packets dropped because the destination MAC address was not one of the
addresses listed under Permit MAC.
MAC addresses to which clients in the VLAN are allowed to send traffic at Layer 2.
Number of packets whose source MAC address was a client in this VLAN, and whose
destination MAC address was one of those listed under Permit MAC.
Hits
5947
9
0
Discription
1