Set Spantree Fwddelay - D-Link DWS-1008 Cli Reference Manual

Defaults: STP backbone fast path convergence is disabled by default.
Access: Enabled.
Usage: If you plan to use the backbone fast convergence feature, you must enable it on all the
bridges in the spanning tree.
Examples: The following command enables backbone fast convergence:
DWS-1008# set spantree backbonefast enable
success: change accepted.
See Also:
• show spantree backbonefast

set spantree fwddelay

Changes the period of time after a topology change that a switch which is not the root bridge
waits to begin forwarding Layer 2 traffic on one or all of its configured VLANs. (The root bridge
always forwards traffic.)
Syntax: set spantree fwddelay delay {all | vlan vlan-id}
delay
Delay value. You can specify from 4 through 30 seconds.
all Changes the forwarding delay on all VLANs.
vlan vlan-id VLAN name or number. MSS changes the forwarding delay on only the specified
VLAN.
Defaults: The default forwarding delay is 15 seconds.
Access: Enabled.
Examples: The following command changes the forwarding delay on VLAN pink to 20 seconds:
DWS-1008# set spantree fwddelay 20 vlan pink
success: change accepted.
See Also:
• show spantree
D-Link DWS-1008 CLI Manual