Set Vlan Name - D-Link DWS-1008 Cli Reference Manual

Defaults: Layer 2 restriction is disabled by default.
Access: Enabled.
Usage: You can specify multiple addresses by listing them on the same command line or by entering
multiple commands. To change a MAC address, use the clear security l2-restrict command to
remove it, then use the set security l2-restrict command to add the correct address.
Restriction of client traffic does not begin until you enable the permitted MAC list. Use the mode
enable option with this command.
Examples: The following command restricts Layer 2 forwarding of client data in VLAN abc_air to
the default routers with MAC address aa:bb:cc:dd:ee:ff and 11:22:33:44:55:66:
DWS-1008# set security l2-restrict vlan abc_air mode enable permit-mac
aa:bb:cc:dd:ee:ff 11:22:33:44:55:66
success: change accepted.
See Also:
• clear security l2-restrict
• clear security l2-restrict counters
• show security l2-restrict

set vlan name

Creates a VLAN and assigns a number and name to it.
Syntax: set vlan vlan-num name name
vlan-num VLAN number. You can specify a number from 2 through 4093.
name String up to 16 alphabetic characters long.
Defaults: VLAN 1 is named default by default. No other VLANs have default names.
Access: Enabled.
Usage: You must assign a name to a VLAN (other than the default VLAN) before you can add
ports to the VLAN.
D-Link recommends that you do not use the name default. This name is already used for VLAN
1. D-link also recommends that you do not rename the default VLAN. You cannot use a number
as the first character in the VLAN name. D-Link recommends that you do not use the same name
with different capitalizations for VLANs. For example, do not configure two separate VLANs with
the names red and RED.
D-Link DWS-1008 CLI Manual