D-Link DWS-1008 Cli Reference Manual page 146

SNMPv1 with Traps
To configure a notification target for traps from SNMPv1, use the following command:
Syntax: set snmp notify target target-num ip-addr [:udp-port-number]
v1 community-string [profile profile-name]
target-num
ip-addr [:udp-port-number]
community-string
profile profile-name
Defaults: The default UDP port number on the target is 162. The default minimum required security
level is unsecured. The default number of retries is 0 and the default timeout is 2 seconds.
Access: Enabled.
Usage: The inform or trap option specifies whether the MSS SNMP engine expects the target to
acknowledge notifications sent to the target by the switch. Use inform if you want acknowledgements.
Use trap if you do not want acknowledgements. The inform option is applicable to SNMP version
v2c or usm only.
Examples: The following command configures a notification target for acknowledged
notifications:
DWS-1008# set snmp notify target 1 10.10.40.9 usm inform user securesnmpmgr1
snmp-engine-id ip
success: change accepted.
This command configures target 1 at IP address 10.10.40.9. The target's SNMP engine ID is
based on its address. The MSS SNMP engine will send notifications based on the default profile,
and will require the target to acknowledge receiving them.
The following command configures a notification target for unacknowledged notifications:
DWS-1008# set snmp notify target 2 10.10.40.10 v1 trap
success: change accepted.
D-Link DWS-1008 CLI Manual
ID for the target. This ID is local to the switch and does not
need to correspond to a value on the target itself. You
can specify a number from 1 to 10.
IP address of the server. You also can specify the UDP port
number to send notifications to.
Community string.
Notification profile this SNMP user will use to specify the
notification types to send or drop.
1