Show Arp - D-Link DWS-1008 Cli Reference Manual

Defaults: If this command is not used, then the default time zone is UTC.
Access: Enabled.
Examples: To set the time zone for Pacific Standard Time (PST), type the following command:
DWS-1008# set timezone PST -8
Timezone is set to 'PST', offset from UTC is -8:0 hours.
See Also:
• clear summertime
• clear timezone
• set summertime
• set timedate
• show summertime
• show timedate
• show timezone

show arp

Displays the ARP table.
Syntax: show arp [ip-addr]
ip-addr IP address.
Defaults: If you do not specify an IP address, the whole ARP table is displayed.
Access: All.
Examples: The following command displays ARP entries:
DWS-1008# show arp
ARP aging time: 1200 seconds
Host
-----------------------------------------------------------------------------------------------
10.5.4.51
10.5.4.53
D-Link DWS-1008 CLI Manual
HW Address VLAN
00:0b:0e:02:76:f5 1
00:0b:0e:02:76:f7 1
Type State
DYNAMIC RESOLVED
LOCAL RESOLVED
118