D-Link DWS-1008 Cli Reference Manual page 468

The table below describes the fields in the display when a querier other than the switch is present.
Field
Querier for vlan
Querier-IP
Querier-MAC
TTL
See Also:
• set igmp querier
show igmp receiver-table
Displays the receivers to which a switch forwards multicast traffic. You can display receivers for all
VLANs, a single VLAN, or a group or groups identified by group address and network mask.
Syntax: show igmp receiver-table [vlan vlan-id] [group group-ip-addr/mask-length]
vlan vlan-id
group group-ip-addr/mask-length IP address and subnet mask of a multicast group, in CIDR
Defaults: None.
Access: All.
Examples: The following command displays all multicast receivers in VLAN orange:
DWS-1008# show igmp receiver-table vlan orange
VLAN: orange
Session
----------------------------------------------------------------------------------------
224.0.0.2
237.255.255.255
237.255.255.255
237.255.255.255
237.255.255.255
237.255.255.255
D-Link DWS-1008 CLI Manual
VLAN containing the querier. Information is listed separately for each VLAN.
IP address of the querier interface.
MAC address of the querier interface.
Number of seconds before this entry ages out if the switch does not receive a query message
from the querier.
VLAN name or number. If you do not specify a VLAN, MSS
displays the multicast receivers on all VLANs.
format (for example, 239.20.20.10/24). If you do not specify
a group address, MSS displays the multicast receivers for all
groups.
Port Receiver-IP Receiver-MAC
none none
5 10.10.10.11 00:02:04:06:08:0b 179
5 10.10.10.13 00:02:04:06:08:0d 179
5 10.10.10.14 00:02:04:06:08:0e 179
5 10.10.10.12 00:02:04:06:08:0c 179
5 10.10.10.10 00:02:04:06:08:0a 179
Description
TTL
none undef