D-Link DWS-1008 Cli Reference Manual page 520

8 port 10/100 wireless switch with power over ethernet

Hide thumbs Also See for DWS-1008:

Table of Contents

Creates a new boot profile.

Syntax: create

Defaults: The new boot profile has the same settings as the currently active boot profile by

Access: Boot prompt.

Usage: A DWS-1008 switch can have up to four boot profiles. The boot profiles are stored in

slots, numbered 0 through 3. When you create a new profile, the system uses the next available

slot for the profile. If all four slots already contain profiles and you try to create a fifth profile, the

switch displays a message advising you to change one of the existing profiles instead.

To make a new boot profile the currently active boot profile, use the next command. To change

boot parameter settings, use the change command.

Examples: The following command creates a new boot profile in slot 1 on a switch that currently

has only one boot profile, in slot 0:

boot> create

BOOT Index: 1

BOOT TYPE: c

DEVICE: boot1:

FILENAME: default

FLAGS: 00000000

OPTIONS: run=nos;boot=0