D-Link DWS-1008 Cli Reference Manual page 339

name
Radio profile name.
rate
Minimum number of seconds a radio must remain on its current channel setting
before RF Auto-Tuning is allowed to change the channel. You can specify from 0 to
65535 seconds.
Defaults: The default RF Auto-Tuning channel holddown is 900 seconds.
Access: Enabled.
Usage: The channel holddown applies even if RF anomalies occur that normally cause an
immediate channel change.
Examples: The following command changes the channel holddown for radios in radio profile rp2
to 600 seconds:
DWS-1008# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
See Also:
• set radio-profile auto-tune channel-config
• set radio-profile auto-tune channel-interval
• set radio-profile auto-tune channel-lockdown
• show radio-profile
set radio-profile auto-tune channel-interval
Sets the interval at which RF Auto-Tuning decides whether to change the channels on radios in
a radio profile. At the end of each interval, MSS processes the results of the RF scans performed
during the previous interval, and changes radio channels if needed.
Syntax: set radio-profile name auto-tune channel-interval seconds
Radio profile name.
name
Number of seconds RF Auto-Tuning waits before changing radio channels to
seconds
adjust to RF changes, if needed. You can specify from 0 to 65535 seconds.
Defaults: The default channel interval is 3600 seconds (one hour).
Access: Enabled.
Usage: D-Link recommends that you use an interval of at least 300 seconds (5 minutes). RF
Auto-Tuning can change a radio's channel before the channel interval expires in response to RF
anomalies. Even in this case, channel changes cannot occur more frequently than the channel
holddown interval.
D-Link DWS-1008 CLI Manual