Cfs Static-Peers - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

cfs static-peers

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
cfs static-peers
To enable static peers interface, use the cfs static-peers command. To disable this feature, use the no
form of the command.
Syntax Description This command has no arguments or keywords.
Defaults
Enabled.
Command Modes
Configuration mode.
Command History Release
4.1(1b)
Usage Guidelines This command enables the static peers with status and all the peers in the physical fabric.
The no cfs static-peers displays a warning string, and changes the entire fabric from static to dynamic.
Note
Examples The following example shows how to enable static peers interface:
Switch(config)# cfs static-peers
Warning: This mode will stop dynamic discovery and relay only on these peers.
Do you want to continue?(y/n) [n] y
Switch(config-cfs-static)#ip address 209.165.200.226
Switch(config-cfs-static)#ip address 209.165.200.227
Switch(config-cfs-static)#exit
Switch(config)#
Related Commands Command
show cfs static peers
Cisco MDS 9000 Family Command Reference
4-20
cfs static-peers
no cfs static-peers
Modification
This command was introduced.
Description
Displays configured static peers with status.
Chapter 4 C Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x