Cimserver Loglevel - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

cimserver loglevel

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
cimserver loglevel
To configure the cimserver loglevel filter, use the cimsever loglevel command in configuration mode.
Syntax Description
filter value
1
2
3
4
5
Defaults
None.
Command Modes
Configuration mode
Command History Release
3.3(1a)
Usage Guidelines None.
Examples
The following example displays the cimserver log level:
switch# config
Enter configuration commands, one per line.
switch(config)# cimserver loglevel 2
Current value for the property logLevel is set to "INFORMATION" in CIMServer.
Related Commands Command
show cimserver logs
Cisco MDS 9000 Family Command Reference
4-26
cimserver loglevel filter value
Specifies the cimserver log filter levels. The range is 1 to 5.
Sets the current value for the log level property to trace.
Sets the current value for the log level property to information.
Sets the current value for the log level property to warning.
Sets the current value for the log level property to severe.
Sets the current value for the log level property to fatal.
Modification
This command was introduced.
Description
Displays the cimserver logs.
End with CNTL/Z.
OL-18089-01, Cisco MDS NX-OS Release 4.x
Chapter 4 C Commands