Attach Front Door To Chassis - Cisco Nexus 9804 NX-OS Hardware Installation Manual

Attach Front Door to Chassis

2 Prepare lug
3 Ground the chassis
Step 4 Use the crimping tool to carefully crimp the wire receptacle around the wire; this step is required to ensure a proper
mechanical connection.
Step 5
Insert the two screws through the holes in the grounding lug. Ensure that the grounding lug does not interfere with other
hardware components.
Step 6
Use the Phillips screwdriver to carefully tighten the screws to 60 in-lbs 6.7 (N-m) of torque until the grounding lug is
held firmly to the chassis. Do not overtighten the screws.
Step 7
Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an adequate
chassis ground.
What to do next
Attach the chassis doors.
Attach Front Door to Chassis
Before you begin
Before you can attach the front door to the chassis, you must attach the cable management brackets, bottom
plate, and top hood onto the chassis.
Required tools and equipment:
• Phillips screwdriver with a torque capability (customer supplied)
Step 1
Remove the power shelf bezel from the chassis, if already installed.
This is to ease the installation of chassis doors.
Step 2
On the back side (open side) of one door, pull in on two protruding spring pins so that the pins are held inside the door
frame.
Cisco Nexus 9804 NX-OS Mode Switch Hardware Installation Guide
24
5 Tighten the screws
Unpack and Install the Chassis