Chapter 2
A Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
attribute failover auto
To configure an automatic fallback failover for a virtual device, use the attribute failover auto fallback
command. To revert to the default, use the no form of the command.
Syntax Description
fallback
Defaults
Disabled.
Command Modes
Virtual device submode.
Command History
Release
NX-OS 4.1(1b)
Usage Guidelines
None.
Examples
The following example shows how to configure an automatic failover for a specific virtual device:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# sdv virtual-device name vdev1 vsan 1
switch#(config-sdv-virt-dev)# attribute failover auto
switch#(config-sdv-virt-dev)#
The following example shows how to configure an attribute of a virtual device:
switch# config t
Enter configuration commands, one per line. End with CNTL/Z.
switch(config)# sdv virtual-device name vdev1 vsan 1
switch#(config-sdv-virt-dev)# attribute failover auto fallback
switch(config-sdv-virt-dev)
OL-18089-02, Cisco MDS NX-OS Release 4.x
attribute failover auto [fallback]
no attribute failover auto [fallback]
(Optional) Enables a switchback with an automatic failover.
Modification
This command was introduced.
#
Cisco MDS 9000 Family Command Reference
attribute failover auto
2-31