Clear Crypto Ike Domain Ipsec Sa - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

clear crypto ike domain ipsec sa

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
clear crypto ike domain ipsec sa
To clear the IKE tunnels for IPsec, use the clear crypto ike domain ipsec sa command.
Syntax Description
tunnel-id
Defaults None.
Command Modes EXEC mode.
Command History Release
2.0(x)
Usage Guidelines To use this command, the IKE protocol must be enabled using the crypto ike enable command.
If the tunnel ID is not specified, all IKE tunnels are cleared.
Examples The following example shows how to clear all IKE tunnels:
switch# clear crypto ike domain ipsec sa
Related Commands Command
crypto ike domain ipsec
crypto ike enable
show crypto ike domain
ipsec
Cisco MDS 9000 Family Command Reference
4-38
clear crypto ike domain ipsec sa [tunnel-id]
(Optional) Specifies a tunnel ID. The range is 1 to 2147483647.
Modification
This command was introduced.
Description
Configures IKE information.
Enables the IKE protocol.
Displays IKE information for the IPsec domain.
Chapter 4 C Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x