Crypto Map Domain Ipsec (Interface Configuration Submode) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

crypto map domain ipsec (interface configuration submode)

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
crypto map domain ipsec (interface configuration submode)
To configure an IPsec crypto map on a Gigabit Ethernet interface, use the crypto map domain ipsec
command in interface configuration submode. To remove the IPsec crypto map, use the no form of the
command.
Syntax Description
map-name
Defaults None.
Command Modes Interface configuration submode.
Command History Release
2.0(x)
Usage Guidelines To use this command, IPsec must be enabled using the crypto ipsec enable command.
The sequence number determines the order in which crypto maps are applied.
Examples The following example shows how to specify an IPsec crypto map for a Gigabit Ethernet interface:
switch# config terminal
switch(config)# interface gigabitethernet 1/2
switch(config-if)# crypto map domain ipsec IPsecMap
Related Commands Command
crypto ipsec enable
show crypto map domain ipsec Displays IPsec crypto map information.
show interface
Cisco MDS 9000 Family Command Reference
4-148
crypto map domain ipsec map-name
no crypto map domain ipsec
Specifies the map name. Maximum length is 63 characters.
Modification
This command was introduced.
Description
Enables IPsec.
Displays interface information.
Chapter 4 C Commands
OL-18089-01, Cisco MDS NX-OS Release 4.x