Deadtime (Radius Group Configuration) - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 5 D Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

deadtime (radius group configuration)

To configure a periodic time interval where a nonreachable (nonresponsive) RADIUS server is
monitored for responsiveness, use the deadtime command in RADIUS group configuration submode.
To disable the monitoring of the nonresponsive server, use the no form of the command.
Syntax Description
time
Defaults
Zero.
Command Modes
RADIUS group configuration submode.
Command History Release
3.0(1)
Usage Guidelines If the dead time interval for an individual RADIUS server is greater than zero (0), that value takes
precedence over the value set for the server group.
When the dead time interval is 0 minutes, RADIUS server monitoring is not performed unless the
RADIUS server is part of a server group and the dead time interval for the group is greater than 0
minutes.
Examples
The following example shows the deadtime command in RADIUS group configuration submode:
switch# config terminal
switch(config)# aaa group server radius testgroup
switch(config-radius)# deadtime 10
Related Commands Command
radius-server
deadtime
show radius-server
OL-18089-01, Cisco NX-OS Release 4.x
deadtime time
no deadtime time
Specifies the time interval (in minutes) for monitoring the server. The time
range is 1 to 1440 minutes.
Modification
This command was introduced.
Description
Sets a time interval for monitoring a nonresponsive RADIUS server.
Displays RADIUS server information.
deadtime (radius group configuration)
Cisco MDS 9000 Family Command Reference
5-3