Auto-Volgrp - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

auto-volgrp

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
auto-volgrp
To configure the automatic volume grouping, use the auto-volgrp command. To disable this feature, use
the no form of the command.
Syntax Description This command has no arguments or keywords.
Defaults
Disabled.
Command Modes
Cisco SME cluster configuration submode.
Command History Release
3.2(2)
Usage Guidelines If Cisco SME recognizes that the tape's barcode does not belong to an existing volume group, then a new
volume group is created when automatic volume grouping is enabled.
Examples The following example enables automatic volume grouping:
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# auto-volgrp
switch(config-sme-cl)#
The following example disables automatic volume grouping:
switch# config t
switch(config)# sme cluster c1
switch(config-sme-cl)# auto-volgrp
switch(config-sme-cl)#
Related Commands Command
show sme cluster
Cisco MDS 9000 Family Command Reference
2-40
auto-volgrp
no auto-volgrp
Modification
This command was introduced.
Description
Displays Cisco SME cluster information.
Chapter 2 A Commands
OL-18089-02, Cisco MDS NX-OS Release 4.x