Action Reload - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

action reload

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
action reload
To configure the reloading or to reload the switch software when an Embedded Event Manager (EEM)
applet is triggered, use the action reload command. To remove the switch software of reload
configuration, use the no form of this command.
Syntax Description
number
.number2
module slot
-slot
Defaults
None.
Command Modes Embedded Event Manager mode.
Command History Release
NX-OS 4.1(3)
Usage Guidelines
None.
Examples
The following example shows how to enable the default action of a policy being overridden when an
EEM applet is triggered:
switch# configure terminal
switch(config)# event manager applet default-applet
switch(config-applet)# action 1.0 policy-default
switch(config-applet)#
Related Commands Command
event manager applet
Cisco MDS 9000 Family Command Reference
2-20
action number [.number2] reload [module slot [- slot]]
no action number [.number2] reload [module slot [- slot]]
Number can be any number up to 16 digits. The range for number2 is from
0 to 9.
(Optional) Specifies the slot range. The range is from 1 to 10, or a
substituted parameter.
Modification
This command was introduced.
Description
Displays an applet with the Embedded Event Manager.
Chapter 2 A Commands
OL-18089-02, Cisco MDS NX-OS Release 4.x