Attach Front Door To Chassis - Cisco Nexus 9808 Hardware Installation Manual

Attach Front Door to Chassis

Figure 20: Top Hood
Step 10 Secure the top hood with the cable management brackets by using four M4 x 6 mm pan-head Phillips screws.
Tighten each screw to 11.5 to 15 in-lb (1.3 to 1.7 N·m) of torque.
Step 11 Tighten the cable management brackets screws to 11.5 to 15 in-lb (1.3 to 1.7Nm) of torque after completing
the bottom cover, and top hood installation.
Attach Front Door to Chassis
Before you begin
Before you can attach the front door to the chassis, you must attach the cable management brackets, bottom
plate, and top hood onto the chassis.
Required tools and equipment:
• Phillips screwdriver with a torque capability (customer supplied)
• Door kit (N9K-C9808-DF-KIT)
Note
Cisco Nexus 9808 NX-OS Mode Switch Hardware Installation Guide
32
The door kit is optional.
Unpack and Install the Chassis