Contract-Id - Cisco AJ732A - MDS 9134 Fabric Switch Command Reference Manual

Chapter 4 C Commands
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m

contract-id

To configure the service contract ID of the customer with the Call Home function, use the contract-id
command in Call Home configuration submode. To disable this feature, use the no form of the command.
Syntax Description customer-id
Defaults None.
Command Modes Call Home configuration submode.
Command History Release
1.0(2)
Usage Guidelines None.
Examples The following example shows how to configure the contract ID in the Call Home configuration:
switch# config terminal
Enter configuration commands, one per line.
switch(config)# callhome
switch(config-callhome)# contract-id Customer1234
Related Commands Command
callhome
callhome test
show callhome
OL-18089-01, Cisco MDS NX-OS Release 4.x
contract-id customer-id
no contract-id customer-id
Configures the service contract ID of the customer. Allows up to 64
characters for the contract number.
Modification
This command was introduced.
Description
Configures the Call Home function.
Sends a dummy test message to the configured destination(s).
Displays configured Call Home information.
End with CNTL/Z.
Cisco MDS 9000 Family Command Reference
contract-id
4-115