Table of Contents
Advertisement
M-series and MX-series Devices
Related
Documentation
Configuring Device Features
46
When you use NSM to edit the software configuration on the device, you initially make
the changes to a device object that models the device in NSM. When you are satisfied
with your configuration changes, you use the Update Device directive to push the
configuration from the device object in NSM to the device itself. At that point, the edited
configuration becomes active.
NOTE: If you import an existing device configuration, NSM automatically
imports all objects defined in that configuration.
For more information about editing device configurations, using device templates, using
configuration groups, and using configuration groups with templates, see "Configuring
Devices" in the Network and Security Manager Administration Guide.
About Device Configuration on page 43
Configuring Device Features on page 46
Example: Configuration of Interfaces for MPLS in the CLI and NSM on page 47
You can configure JUNOS software features in NSM. Although the configuration screens
rendered in NSM look different than the JUNOS command-line interface (CLI), the
top-level configuration elements mostly correspond to commands in the CLI.
NOTE: For detailed information about configuring specific features for
M-series and MX-series devices, see the appropriate JUNOS software
configuration guide.
To configure a device that has been added, imported, or modeled in NSM:
In the navigation tree, select Device Manager > Devices.
1.
Open the device configuration using one of the following methods:
2.
Double-click the device object in the security device tree or the device list.
Select the device object and then click the Edit icon.
Right-click the device object and select Edit.
Select the Configuration tab.
3.
The device configuration tree appears in the left pane.
In the device navigation tree, select a function heading to see device parameters, and
4.
then select the configuration parameter you want to configure.
Make your changes to the device configuration, then choose one of the following:
5.
Click OK to save your changes and close the device configuration.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
