Configuring A Qos Profile - Juniper JUNOSE 11.1.X - QUALITY OF SERVICE CONFIGURATION GUIDE 3-21-2010 Configuration Manual

JUNOSe 11.1.x Quality of Service Configuration Guide
Table 14: Interface Types and Supported Commands (continued)
Related Topics

Configuring a QoS Profile

Before you configure a QoS profile:
To configure a QoS profile:
1.
2.
132
Configuring a QoS Profile
Interface Type Queue
ip
ip-tunnel
ipv6
l2tp-session
l2tp-tunnel
lsp
serial
server-port
svlan
vlan
Supported Interface Types for QoS Profiles on page 131
Configuring a QoS Profile on page 132
Configuring Shadow Nodes on page 152
Configure the traffic classes.
See "Configuring Traffic Classes That Define Service Levels" on page 14.
Configure the queuing hierarchy.
See "Configuring Queue Profiles to Manage Buffers and Thresholds" on page 22.
Configure the scheduler hierarchy and shaping with scheduler profiles.
See "Configuring a Scheduler Hierarchy" on page 47.
Create a QoS profile and enter QoS Profile Configuration mode.
host1(config)#qos-profile qosp-vc-queuing
host1(config-qos-profile)#
(Optional) Configure a group node for each interface.
Shadow
Node Group Node
–
–
–
–
–
–
–
–